-40%
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE
W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE

W M BERG ANODIZED ALUMINUM TIMING PULLEY / SPROCKET FOR MOTOR SHAFT 12MM BORE

$ 13.2

Availability: 100 in stock
  • Number Of Teeth: 21
  • Country/Region of Manufacture: United States
  • Bore Diameter: 12 MM
  • MPN: 37TP112-21
  • Brand: WINFRED M BERG
  • Model: PIN HUB 2 SET SCREWS
  • Condition: 3 WERE TORN OFF OF THE BACKER CARDS BUT NOT USED. EACH ONE WAS WRAPPED IN BROWN PAPER SO THEY ARE FLAWLESS JUST LIKE THE WRAPPED ONES. NOW STORED WITH DESICCANT PACK TO CONTROL MOISTURE.
  • All returns accepted: ReturnsNotAccepted
  • Gear Material: ANODIZED ALUMINUM

    Description

    DRAWER 46
    BUY IT NOW IS FOR ONE PIECE
    THESE ARE JUST A FEW THOUSANDTHS SHY OF 1/2" SO THEY ARE VERY EASY TO REAM OUT TO .500" FOR ONE OF OUR BODINE MOTORS OR YOUR 1/2" SHAFT.
    WARNING DO NOT PAY FOR THESE FROM A MOTION DISTRIBUTOR !
    SAME DAY SHIPPING IF PAID BEFORE NOON EASTERN TIME !
    .50 FLAT SHIPPING RATE FOR ANY QUANTITY !
    THIS TIMING PULLEY USES EXOTIC PROPRIETARY DRIVE BELTS THAT ARE EXPENSIVE AND HARD TO FIND.  YOU HAVE TO USE THEIR EXPENSIVE TIMING BELTS.  I DO NOT HAVE ANY NOR WILL I MAKE ANY CLAIMS AS TO WHAT WILL WORK OR NOT WORK WITH THIS PART. YOU MUST KNOW WHAT IT IS FOR AND WHAT IT IS
    COMPATIBLE
    WITH.
    MOST PEOPLE BUY THESE TO MAKE THEIR OWN PULLEYS ON A LATHE.
    YOU TURN THE TEETH OFF AND MACHINE A GROOVE INTO IT TO MATCH THE WIDTH OF YOUR BELT.
    YOUR PULLEY WILL HAVE THE TEETH INTACT.
    BUY ONE AND PUT IT ON YOUR LATHE AND TURN IT INTO WHATEVER YOU NEED.
    These will be
    rolled in
    bubble wrap to protect the teeth from damage
    These would never be placed together so that the teeth would scratch one another.
    PLEASE NOTE THAT NONE OF THE EXTRAS OR MEASURING INSTRUMENTS ARE PART OF THE SALE.
    If you pay before noon Eastern time these will be mailed the same day !